MOTOROLA RADIO PROGRAMMING 98632 INSTALL
MOTOROLA RADIO PROGRAMMING 98632 SERIAL
MOTOROLA RADIO PROGRAMMING 98632 SOFTWARE

This completes the programming of the Pi's software configuration. If you can it is best to cut and paste each line separately to the Pi Linux prompt. It is important that these commands are executed as shown. Then execute the following commands at the Linux prompt -Д®cho 'AddressFamily inet' > /etc/ssh/sshd_configД®cho 'X11Forwarding yes' > /etc/ssh/sshd_configД®cho 'X11UseLocalhost no' > /etc/ssh/sshd_configД®cho 'XAuthLocation /usr/bin/xauth' > /etc/ssh/sshd_config If you want to use an exisiting old RIB box and cable it may not work unless it is self powered as the FTDI cable may not supply the required current.ДЄssuming you already have a configured hamvoip V1.5 system that has been updated to the latest version you will need to download the dosprogs package from the hamvoip repository using the following command at the Linux prompt. Make sure you get a 'ribless' cable, one with RS232 to TTL conversion in the cable.

Google 'Motorola Programming Cable' or try this link. Motorola Radius Maxtrac GM300 M1225 CDM1250 CM200 CM300Д¬ables for other radios are available.

Programming cable DB9 to Radio - Choose for your radio - Maxtrac and others.

Clone FTDI chips may work but have not been tested. This MUST be an FTDI cable, Prolific, etc.

MOTOROLA RADIO PROGRAMMING 98632 SERIAL

True FTDI USB to 9 pin serial adapter available at Amazon.Raspberry Pi with updated hamvoip V1.5 software, additional package download required.Here are the suggested parts required for programming Be aware that this uses a supplied custom compiled dosbox which works with the FTDI controller to supply the required custom baudrates that the Motorola radios require. All timings and configurations have been preset and so far have worked with all tested radios. The Motorola programming packages run under this MSDOS environment.

MOTOROLA RADIO PROGRAMMING 98632 INSTALL

Because it was not desirable to install the entire graphics package in the hamvoip installation, which would be necessary to run DOSBOX directly on the Pi, we instead do X11 forwarding to an X11 server where the program is displayed. The Raspberry Pi is an excellent platform to do this as it is readily available and provides a consistent environment to run the code.

The hamvoip programming package uses dosbox a program to simulate MSDOS. This also could add the ability to program a radio at a remote site without being there. This works on the hamvoip Archlinux installation and can be used in conjunction with a running Allstar system in fact I have used a node on the same server while I was programming without any problems. Most would either not have the software or proper hardware.Д«ecause of this we have implemented a novel approach that should work consistently using a Raspberry Pi, the hamvoip software, and a couple of inexpensive cables. It was widely accepted that you would need an old slow computer with a dedicated serial port to do this and trying anything else either did not work or was very finicky. One of the sticking points of using these radios has been the programming which required access to the software and more importantly a computer and hardware that was able to do it. Since the commercial changeover to narrow-band some years ago a great deal of the now unusable commercial equipment is available to the amateur community. For many years hams have been using Motorola commercial radios modified for amateur radio use.

Motorola radio programming 98632